Motherboard Specifications, IPIEL-LA3 (Eureka3)
- Manufacturer's motherboard name: Pegatron IPIEL-LA3
- HP/Compaq name: Eureka3-GL8
- 24.5 cm (9.6 in) x 24.5 cm (9.6 in)
- Intel G43 Express
- 1333/1066/800 MHz
- TDP: 95W
- Motherboard supports the following processor upgrades:
- Intel Core 2 Quad (Yorkfield core) series
- Intel Core 2 Duo (Wolfdale core) Dual Core series
Memory upgrade information:
- Four DDR3 DIMM (240-pin) sockets
- Supports 2 GB DDR3 DIMMs
- Supports dual channel memory architecture
- Supported speeds:
- PC3-8500 @ 1066 MHz
- PC3-6400 @ 800 MHz
- Non-ECC memory only, unbuffered
- Supports up to 8 GB on 64-bit PCs
- Supports up to 4 GB* on 32-bit PCs
Supports PCI Express x16 graphics card
REMARQUE :Either integrated graphics or the PCI Express x16 slot are usable at one time; they are not usable concurrently.
Integrated High Definition audio
- Audio CODEC: Realtek ALC888S
- High Definition 7.1 channel audio
- Technology: Realtek 8111DL
- Data transfer speeds: up to 10/100/1000 Mb/s
- Transmission standards: Gigabit 10-Base-GT Ethernet
- One PCI Express x16 graphics (for a graphics card)
- Three PCI Express x1 (for cards such as network, sound, tv-tuner)
Figure 2: Back I/O panel
1 - Coaxial SPDIF Out port.
2 - Video Graphics Adapter port.
3 - RJ45 Network (LAN)
4 - Audio: Center/Subwoofer (yellow orange)
5 - Audio: Rear Speaker Out (black)
6 - Audio: Line In (light blue)
7 - Audio: Line Out (lime)
8 - Audio: Microphone (pink)
9 - Side Speaker Out (gray)
10 - USB 2.0: 4
11 - DVI port
- One 24-pin ATX power connector
- One 4-pin ATX power connector
- One CPU fan connector
- One PC fan connector
- Four SATA connectors
- Two USB 2.0 connectors (dual ports)
- Four USB 2.0 connectors (single port) (Note: Some USB ports may not be available externally.)
- One S/PDIF audio out connector
- One 9-pin audio header for headphone-out and microphone-in (yellow, requires matching front audio jack module)
- One 9-pin header for for power button, reset button, power LED, and HDD LED
- One jumper for resetting BIOS settings
- One jumper to disable BIOS password checking
ATTENTION : Do not change any jumper setting while the computer is on. Damage to the motherboard can result.
This motherboard has a jumper to clear the Real Time Clock (RTC) RAM in CMOS.
The BIOS password is used to protect BIOS settings from unwanted changes. If you have forgotten your password you may disable password checking.
To erase the BIOS password follow these steps:
- Turn OFF the computer and unplug the power cord.
- Locate the jumper labeled CLEAR_PWD. In the default (normal) position the jumper is on pins 3-5.
- Move the jumper on jumper CLEAR_PWD to pins 1-3 to clear password.
- Plug in the power cord and turn ON the computer.
- Hold down the F10 key during the startup process and enter BIOS setup to change or clear the password.
- After changing or clearing the BIOS passwords, remember to reset the jumper to pins 3-5.