Jump to content

HP Photosmart Plus e-All-in-One Printer - B210a support

Loading Plain Paper, Photo Paper, and Envelopes

  • PrintPrint

Introduction

This document provides instructions for loading plain paper, photo paper, and envelopes.
Use the following steps to load paper in the product.
  1. Raise and hold the output tray in the open position.
  2. Slide the paper width guide to its outermost position.
    Figure 1: Slide the paper guide outward
    Graphic: Move the paper width guide outward
  3. Insert the paper stack into the input tray with the short edge forward and print side down.
    Figure 2: Load plain paper
    Graphic: Load plain paper
  4. Slide the paper width guide inward until it rests against the stack of paper.
    Figure 3: Slide the paper width guide inward
    Graphic: Slide the paper width guide to rest against the paper stack
  5. Lower the output tray, and then pull the tray extender towards you, as far as it will go. Flip the paper catch at the end of the tray extender.
    Figure 4: Lower the output tray
    Graphic: Lower the output tray
Use the following steps to load photo paper in the product.
  1. Raise the photo tray lid, and then slide the paper width guide outward.
    Figure 5: Raise the photo tray lid and slide the paper width guide outward
    Graphic: Raise the photo tray lid, and then slide the paper width guide outward
  2. Insert the stack of photo paper into the photo tray with the short edge forward and print side down. Slide the stack forward until it stops.
    NOTE:If the photo paper you are using has perforated tabs, load the paper so that the tabs are closest to you.
    Figure 6: Load photo paper
    Graphic: Load photo paper
  3. Slide the paper width guide inward until it stops at the edge of the paper.
    Figure 7: Slide the paper width guide inward
    Graphic: Slide the paper width guide inward
  4. Lower the photo tray lid.
    Figure 8: Lower the photo tray lid
    Graphic: Lower the photo tray lid
    NOTE:Do not leave any photo paper in the input tray after you finish printing, as the quality of the paper might deteriorate. Store photo paper in a sealed bag in a cool, dark place.
Use the following steps to load envelopes in the product.
NOTE:You can load one or more envelopes in the tray, but do not load more than five envelopes at a time. Do not use shiny or embossed envelopes or envelopes that have clasps or windows.
  1. Raise and hold the output tray in the open position.
  2. Slide the paper-width guide to its outermost position.
    Figure 9: Slide the paper guide outward
    Graphic: Move the paper-width guide outward
  3. Insert one or more envelopes into the far-right side of the input tray with the envelope flaps on the left and facing up.
    Figure 10: Load envelopes
    Graphic: Load envelopes
  4. Slide the paper width guide inward until it stops at the edge of the envelopes.
    Figure 11: Slide the paper width guide inward
    Graphic: Slide the paper width guide inward to rest on the edge of the envelopes
  5. Lower the output tray.
    Figure 12: Lower the output tray
    Graphic: Lower the output tray
HP Photosmart Plus e-All-in-One Printer - B210a

HP Support forums

Find solutions and collaborate with others on the HP Support Forum
HP on YouTube