PrintMotherboard specifications table
| Form factor | Micro ATX |
| Processor socket type | 478 |
| Processor front side bus frequency | 400/533/800 MHz |
| Maximum approved processor |
|
| Chipset "North Bridge" | SiS661fx |
| Chipset "South Bridge" | SiS964 |
| Memory type | PC2700/PC3200 DDR |
| Memory sockets | 2 DDR DIMM (184-pin) sockets |
| Maximum memory | 1 GB (2 x 512 MB DDR-DIMMS) |
| SATA connectors | None |
| Graphics | Down |
| Graphics connector (AGP) | 1 AGP 8X |
| Audio | Integrated AC97 v2.2 Audio |
| AC'97 CODEC device | Realtek ALC650 |
| Audio jacks (Legend below ) | M, LI, LO |
| Ethernet 10/100 LAN supplier | RealTek 8100C 10/100 |
| Ethernet configuration | Integrated, Down |
| IEEE 1394 Front/Back options | 1F + 1B |
| IDE UDMA modes | ATA-100 |
| Expansion slots (AGP/PCI) | 1 AGP, 3PCI, 1 PCI Expansion |
| USB ports | 4 |
| Serial, parallel, floppy, PS2 keyboard and mouse | 1S, 1P, 1F, PS2 K+M |
| Available manufacturing options (Legend below ) | GLE6 |
| Legend | Meaning |
|---|---|
| 8 | 8-Channel audio |
| A | Audio integrated on motherboard |
| C | External L2 cache on motherboard |
| E | 1394 on motherboard |
| G | Graphics integrated on motherboard or in chipset |
| L | LAN on motherboard (Ethernet) P - PCMCIA slot |
| LI | Line In |
| LO | Line out |
| M | Microphone |
| M/G | Midi/Game |
| S | S3 power management support |
| S/O | Speaker |
| T | TV-out on motherboard |
| U | Graphics card (Non integrated on motherboard) |
| W | Microsoft Windows XP hardware compliant |
Clearing the CMOS settings
The JP1 jumper allows you to clear the Real Time Clock (RTC) in CMOS. It also allows clearing of date, time, and system setup parameter memories in CMOS, by erasing the RTC RAM data. The onboard button cell battery powers the RAM data in CMOS, including system setup information.
CAUTION: Do not change any jumper setting while the computer is on. Damage to the motherboard can result.
To clear password set jumper JP3 to pins 2-3.
Clearing the BIOS password
The BIOS password protects the BIOS from undesired changes. If password checking is enabled, and you need to enable it, use the following steps:
To clear password set jumper JP1 to pins 2-3.
