Jump to content
HP Customer Support

Motherboard Specifications, 865G7MF-SH (Spruce)

  • PrintPrint
  • Share
Figure 1: The 865G7MF-SH (Spruce) motherboard
Show all | Hide all
  • Manufacturer's motherboard name: Foxconn 865G7MF-SH
  • HP/Compaq name: Spruce-GL6
  • Micro-ATX: 24.4 cm (9.6 inches) x 22.4 cm (8.8 inches)
  • Intel 865G
    • Southbridge i865G
    • Northbridge ICH5
  • 800 MHz
Socket type: 775
Motherboard supports the following processor upgrades:
  • Pentium D 900 series Dual Core (Presler)
  • Pentium D 800 series Dual Core (Smithfield)
  • Pentium 4 601 series (Cedar Mill)
  • Pentium 4 600 series (Prescott)
  • Pentium 4 500 and 501 series (Prescott)
  • Celeron D (Prescott)
  • Single-channel memory architecture
  • 2 x 184-pin DIMM sockets support unbuffered non-ECC 400/333 MHz DDR1 memory modules
  • Maximum HP/Compaq approved memory is 2 GB
*Integrated video is not available if a graphics card is installed.
  • AC97 audio
  • Audio CODEC: Realtek ALC653
  • Interface: Integrated into motherboard
  • Technology: Realtek RTL8100C
  • Data transfer speeds: up to 10/100 Mb/s
  • Transmission standards:10-Base-T Ethernet
  • Three PCI
  • One AGP 8X
Figure 2:
1 - PS/2 mouse (green)
2 - Parallel
3 - RJ-45 Network (LAN) .
4 - Audio: Line In (light blue)
5 - Audio: Line Out (lime)
6 - Audio: Microphone (pink)
7 - USB 2.0: 4
8 - Video Graphics Adapter
9 - Serial
10 - PS/2 keyboard (purple)
  • One 24-pin ATX power connector
  • One 4-pin ATX + 12V power connector
  • One FDD connector
  • Two Parallel ATA connectors
  • Two Serial ATA connectors
  • One PC fan connector
  • One CPU fan connector
  • One 9-pin header for power button, reset button, power LED, and HDD LED
  • One 9-pin audio header for headphone-out and microphone-in
  • Two USB 2.0 headers supporting 4 USB ports or devices
CAUTION: Do not change any jumper setting while the computer is on. Damage to the motherboard can result.
This motherboard has a jumper to clear the Real Time Clock (RTC) RAM in CMOS.
To clear CMOS, follow these steps:
  1. Temporarily set jumper CLR_CMOS to pins 1-2.
  2. Wait 5-10 seconds and then return the jumper to pins 2-3.
    When you start the system you will need to enter BIOS setup to reset any custom BIOS settings.