Jump to content

HP Pavilion HPE h8-1070t CTO Desktop PC support

Replacing the Power Supply in HP Pavilion HPE h8-1000 and HP ENVY 700 Desktop Series PCs

  • PrintPrint
This document applies to HP Pavilion HPE h8-1000 series desktop computers.
HP Pavilion HPE h8-1000 series desktop computer

Before you begin

  • Turn off the computer. Disconnect the Ethernet or modem cable. Disconnect the power cord.
  • Transfer the computer to a clear, flat, stable work surface over a non-carpeted floor.
  • HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the computer.
  • Do not remove a component from its protective packaging until you are ready to install it.
WARNING:The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the computer.
CAUTION:This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a noncarpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.

Video overview

View the following video before using the steps in this article.
NOTE:For best quality on dial-up connections, wait until the video has fully loaded before viewing.

Removing the power supply

Use the steps in this section to remove the power supply.
WARNING:Make sure the computer is disconnected from power before starting.
Step 1

Remove the side panel.

For more information about removing the side panel, refer to the HP support document Removing and Replacing the Side Panel .
Pulling off the panel
Step 2

Detach all power connectors to the motherboard,...
Motherboard power connectors
all optical drives,...Optical drive power connectors
...and hard drives.Hard drive power connectors
Step 3

Remove the four screws that connect the power supply to the computer.

Save the screws for power supply replacement.
Removing the four screws
Step 4

Press the latch at the bottom of the power supply, and...
Power supply latch
...pull the power supply into and out of the computer.Removing the power supply

Replacing the power supply

Use the steps in this section to replace the power supply.
WARNING:Always replace the entire power supply. Never attempt to disassemble the power supply or work on components within the power supply unit.
Step 1

Find the latch, guide, and ledge inside the computer that help secure the power supply.
Inside of computer
1 - Latch
2 - Guide
3 - Ledge
Step 2

Align the power supply with the ledge and guide, and...
Aligning the power supply
...slide it back until it snaps into place. Sliding the power supply
Step 3

Replace the four screws that connect the power supply to the computer.
Replacing the four screws
Step 4

Reconnect all power connectors to the motherboard, optical drives, and hard drives.
Motherboard power connectors
Step 5

Replace the side panel.

For more information about replacing the side panel, refer to the HP support document Removing and Replacing the Side Panel .
Replacing the panel
HP Pavilion HPE h8-1070t CTO Desktop PC

HP Support forums

Find solutions and collaborate with others on the HP Support Forum
HP.comHP on FacebookHP on TwitterHP on YouTubeHP on Linked InHP on FlickrHP on Google+