Jump to content

Removing the Front Cover in HP Pavilion Media Center TV m7000/8000 Series Desktop PCs

  • PrintPrint
This document only pertains to HP desktop PCs with the following PC case:

Before you begin

  • Turn off the PC, disconnect all cables and transfer the PC to a clear, flat, stable work surface over a non-carpeted floor.
  • HP strongly recommends the use of an anti-static wrist strap and a conductive foam pad when working on the PC.
WARNING:The edges of metal panels can cut skin. Be careful not to slide skin along any interior metal edge of the computer.
CAUTION:This product contains components that can be damaged by electrostatic discharge (ESD). To reduce the chance of ESD damage, work over a noncarpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected to a grounded surface.

Video overview

View the following video before using the steps in this article.
NOTE:For best quality on dial-up connections, wait until the video has fully loaded before viewing.

Removing the front cover

To replace the power switch, the optical drives, the front I/O panel, the hard drive, or the memory card reader, the front outer cover must be removed.
WARNING:Make sure the computer is disconnected from power before starting.
Step 1. With all cables disconnected from the PC, remove both side panels.

For more information about removing the side panels, you can refer to the HP support document Opening the PC Case .
Step 2. From inside the PC, press the three tabs on the left side of the front cover.
Step 3. Rotate the front cover off of the PC.

CAUTION:Be careful to not bend or break the three tabs on the right side of the front cover.

Replacing the front cover

Step 1. Align the six tabs on the front cover ...
... with the six slots on the front of the PC.
Step 2. Snap the bezel into position.

HP Support forums

Find solutions and collaborate with others on the HP Support Forum
HP.comHP on FacebookHP on TwitterHP on YouTubeHP on Linked InHP on FlickrHP on Google+