Jump to content

'Door Open' Error Message Displays on the Control Panel

  • PrintPrint

Issue

The 'Door Open' error message displays on the control panel of the product.

Solution

Follow these steps to resolve the issue.

Step one: Close the cartridge door completely

If the cartridge door is not completely closed, the error message displays.
  1. Open, and then close the cartridge door of the product. Make sure that the door rests securely against the body of the product.
    Figure 1: Examples of closing the cartridge door (your product might vary)
    Illustration of different ways cartridge doors close.
    NOTE:To see how to close the cartridge door of your specific model, see the cartridge section of your product's User Guide.
  2. Check the product control panel to see if the error message still displays.
  • If these steps resolved the issue , there is no need to continue troubleshooting.
  • If the issue persists , see the next step.

Step two: Check the cartridge door for obstructions

  1. Inspect the door and the area around it to make sure that no obstructions prevent the door from closing completely.
    NOTE:Bits of paper, packing materials, and tape might prevent the door from closing completely.
  2. Remove any obstructions.
  3. Check the product control panel to see if the error message still displays.
  • If these steps resolved the issue , there is no need to continue troubleshooting.
  • If the issue persists , see the next step.

Step three: Reset the product

  1. Press the Power button ( ) to turn on the product.
  2. Disconnect the USB cable from the back of the product.
  3. Disconnect the power cord from the electrical outlet.
  4. Disconnect the power cord from the product.
  5. Wait 30 seconds.
  6. Reconnect the power cord to the electrical outlet.
  7. Reconnect the power cord to the product.
  8. Press the Power button ( ) to turn on the product.
  9. Reconnect the USB cable to the product.
  10. Check the product control panel to see if the error message still displays.
  • If these steps resolved the issue , there is no need to continue troubleshooting.
  • If the issue persists , see the next step.

Step four: Service the product

If you have completed all the steps listed above and still experience a problem, the door sensor or door sensor activator might be broken or damaged. In that case, service the product.

HP Support forums

Find solutions and collaborate with others on the HP Support Forum
HP.comHP on FacebookHP on TwitterHP on YouTubeHP on Linked InHP on FlickrHP on Google+