Jump to content

Send a Fax from the Scanner Glass or the Automatic Document Feeder

  • PrintPrint

Introduction

This document provides information on how to send a fax by sending originals from the scanner glass and the automatic document feeder (ADF).

Sending a fax from the scanner glass

Follow the steps below to send a fax from the scanner glass. Load only one original document on the scanner glass to send as a fax.
  1. Remove all originals from the document feeder tray, and then lift the lid.
  2. Load the original, print side down in the right-front corner of the glass. Align the original to the engraved guides on the edge of the glass.
  3. Close the lid.
  4. On the control panel, to enter a fax number, do one of the following:
    • Use the keypad to type a fax telephone number.
    • Press Speed Dial to select a speed dial entry.
    • Press Redial/Pause to select the last number entered.
  5. Press START FAX Black or START FAX Color . The device scans the original, dials the fax number and sends the fax.

Sending a fax from the automatic document feeder (ADF)

Follow the steps below to send a fax from the automatic document feeder (ADF). Load multiple originals into the ADF to send in a single fax.
  1. Turn the originals print-side up.
  2. Slide the originals into the automatic document feeder until hearing a beep or seeing a message on the display indicating that the loaded pages were detected.
  3. Slide the width guides inward until they stop at the left and right edges of the paper.
  4. On the control panel, to enter a fax number, do one of the following:
    • Use the keypad to type a fax telephone number.
    • Press Speed Dial to select a speed dial entry.
    • Press Redial/Pause to select the last number entered.
  5. Press START FAX Black or START FAX Color . The device feeds the originals, one sheet at a time onto the scanner glass. The device scans each original sheet, dials the fax number, and sends the fax.