Motherboard Specifications, M2N68-LA (Narra6)
Motherboard supports the following processor upgrades:
Socket type: AM3
TDP: 95 watt
- AMD Phenom II X4 9xx/9xxe/8xx Quad-Core (Deneb)
- AMD Phenom II X3 7xx/7xxe Triple-Core (Heka)
- AMD Phenom II X2 5xx (Callisto)
- AMD II Athlon X4 6xx/6xxe (Propus)
- AMD II Athlon X3 4xx/4xxe (Rana)
- AMD II Athlon X2 2xx/2xxe (Regor)
- AMD Sempron 1xx (Sargas)
- Dual channel memory architecture
- Two DDR3 DIMM (240-pin) sockets
- Supported DIMM types:
- PC3-8500 (DDR3-1066)
- PC3-10600 (DDR3-1333)
- Non-ECC memory only, unbuffered
- Supports 2GB DDR2 DIMMs
- Supports up to 4 GB* on 32 bit PCs
*32-bit operating systems cannot address a full 4.0 GB of memory.
- One CPU fan connector
- One 24-pin ATX power connector
- One 4-pin ATX power connector
- One ROM recovery connector
- Four SATA connectors
- One ROM recovery connector
- One jumper for resetting BIOS settings
- One jumper to clear the BIOS password setting
- One system panel connector
- One AC Power Loss Restart Selector
- Four USB headers, supporting 6 USB connections
- One S/PDIF out connector
- One Front audio connector for headphone and microphone
- One chassis fan connector
The BIOS password is used to protect BIOS settings from unwanted changes. If you have forgotten your password you may disable password checking.
To erase the BIOS password follow these steps:
The NJ18 jumper allows the user to set whether or not to start the PC after power interruptions.
If the jumper is set in the [Disabled] configuration the selector leaves your PC off. If the jumper is set in the [Enabled] configuration the selector starts the PC.
The NJ18 jumper on the motherboard.
NJ18 Header chart.
Other solutions customers found helpful
Recently browsed products
HP Support forums
Find solutions and collaborate with others on the HP Support Forum


Print























