Jump to content

HP Officejet 7410 All-in-One Printer support

Connecting Phone Equipment to the Fax

  • PrintPrint

Introduction

HP fax products are designed so that other telephone equipment can be connected on the same line as the fax. The unit must be connected first using a two-conductor fax/phone cable like the one that shipped with the HP product. Using a four-conductor telephone cable may cause problems receiving faxes or calls.
This document describes how to connect other telephone devices to the fax product in a normal, single-line phone setup. It does not describe how to use the fax on a PBX, ISDN, or DSL Phone System. Refer to HP document Using an HP All-in-One Product on a PBX, ISDN, or DSL Phone System (buu50333) for information on how to connect the unit in these types of systems.
More information about using the fax with telephone answering machines is found in HP document Using HP Fax Products with a Telephone Answering Machine (TAM) (buu04072).
If you are having trouble establishing a dial tone or cannot send or receive faxes, refer to HP document Cannot Send or Receive Faxes (buu02151) for assistance.

Phone cables

There are two different types of phone cables. There are two-conductor phone cables like what originally shipped with the HP fax product and there are four-conductor cables. HP fax products are designed to work with a two-conductor phone cable. Look at the end of the cable and verify that it has only two copper leads or wires. Replace any four-conductor cables with a two-conductor cable. Only two-conductor phone cables should be used to connect the all-in-one to the phone line.
Figure 1: The difference between a two-conductor phone cable and a four-conductor phone cable
1 - A two-conductor cable
2 - A four-conductor cable

Step one: Connect the phone line to the fax

The fax will have two or three sockets (or jacks) for phone lines. Some of these may have a removable plastic plug in them. These sockets will be labeled with text, To Wall Jack, or with a graphic of the wall jack. See Figure 1 below.
Plug the two-conductor telephone cable that came with the HP product into the telephone wall jack. Then, plug it into this socket as shown below.
Figure 2: Connecting the fax to the telephone wall jack
In areas with above ground telephone lines and electrical storms (lightning), it is a good idea to purchase a telephone line surge suppressor and connect it between the telephone wall jack and the fax. This will help prevent damage to the fax from a lightning-caused power surge on the phone line.

Step two: Add other phone-line devices

To connect other telephone devices, use the other socket (or sockets) on the fax. These are identified by text or with a graphic of a telephone and/or computer.
Connect a caller ID unit between the fax and the telephone.
Use the information below that matches the devices you need to connect.

Fax and telephone

Connect a single-line telephone to one of the added sockets on the fax. The telephone will share the same phone line as the fax. See the illustration below.
Figure 3: Fax with telephone connected

Fax, answering machine, and telephone

When a telephone answering machine and telephone are connected, connect the answering machine to the fax and then connect the telephone to the answering machine as shown below.
Figure 4: Fax, answering machine, and telephone

Fax and computer modem

To use a fax and a computer modem on the same phone line, connect the fax to the computer modem. The modem socket on the computer may be labeled Line or Wall jack.
Figure 5: Fax and computer modem

Fax, computer modem, and telephone

To use a computer modem and a telephone with the fax, connect the computer modem to the fax. Then, connect the telephone into the second phone line connector on the computer modem or the third fax socket (if it is available). The image below shows how to connect a computer and a telephone to a fax with two sockets.
Figure 6: Fax, computer modem, and telephone

Fax, modem, answering machine, and telephone

The image below shows how to connect a computer modem, answering machine, and telephone to a fax. Connect the computer modem to the fax, then connect the answering machine to the computer, and finally, connect the telephone to the answering machine.
If the fax has three phone line sockets instead of two, some of the devices can be connected to the other phone socket on the fax.
Figure 7: Fax, computer modem, answering machine, and telephone
HP Officejet 7410 All-in-One Printer

HP Support forums

Find solutions and collaborate with others on the HP Support Forum
HP on YouTube