Jump to content

HP vp6320 Digital Projector support

Lamp Warning Messages and Lights

  • PrintPrint

Introduction

This document pertains to the HP vp6300 series digital projectors.

Lamp warning messages and lights

Over time, the lamp will decrease in brightness or may break and require replacing. The HP digital projector records the length of time the lamp is illuminated and will display warning messages about the lamp usage. When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may break.
NOTE:The Lamp indicator light and Temperature warning light will illuminate if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temperature lights still illuminate after turning the power back on, contact HP.
The warning messages and lights and the actions you should take are listed in the tables below.
Lamp warning messages
Lamp warning messageStatus
Lamp is getting old. Buy a spare lamp.The lamp has been in operation for a long time and you should have a spare lamp available. For optimal performance, install a new lamp.
End of lamp life. Install a new lamp Then hold the Up Arrow to reset lamp hours.The lamp has reached the end of its life, and the projector will not operate normally until you change the lamp.
Figure 1: Lamp warning lights on the projector
1 - Lamp light
2 - Temperature light
Lamp warning lights
Lamp warning lightStatus
Both red warning lights on the projector are blinking.Allow the projector to cool down after it turns off. If this condition occurs after you restart the projector, an internal component has failed. Contact HP for assistance.
The red Temperature light on the projector is on or blinking.Allow the projector to cool down after it turns off. Be sure that nothing is near or blocking the vents on the projector, and that the vents are free of lint and other objects. Remove any sources of excess heat in the room. Observe temperature and altitude limits. If the warning light turns on or blinks after you restart the projector, contact HP for assistance.
The red Lamp light on the projector is on or blinking:Allow the projector to cool down after it turns off. If the warning light turns on or blinks after you restart the projector, install a new lamp. If this occurs after you install a new lamp module, remove and reinstall the lamp module. If a new lamp does not fix the problem, contact HP for assistance.
The red Lamp light is flickering quickly.Check that the cover over the lamp at the side of the projector is correctly installed and fully attached. Check the tab at the top of the cover and latch at the bottom.
HP vp6320 Digital Projector

HP Support forums

Find solutions and collaborate with others on the HP Support Forum
HP.comHP on FacebookHP on TwitterHP on YouTubeHP on Linked InHP on FlickrHP on Google+