HP Officejet 6110 All-in-One Printer Troubleshooting

Setting up the All-in-One (Hardware)

Introduction

This document explains how to set up the physical parts of the product. Complete these steps before you install the product software on your computer. If you already set up the product hardware, and need software installation help, see Links to Software Installation Instructions at the end of this document.

Setting up the product parts includes the following steps:

Attach the ADF tray extension

Attach the front panel cover

Load paper

Connect the phone cord and power cord

Insert and align the cartridges

Setting up the All-in-One

Follow these steps in order. When you are finished, you can click the appropriate link at the end of this document if you need instructions to install the product software.

CAUTION:Do NOT connect the USB cable now. If you need a USB cable to connect the product to the computer, you will be prompted to connect it at the correct time during software installation.

Step one: Attach the ADF tray extension

Slide the automatic document feeder (ADF) tray extension into the top of the product. Match the gray tabs with the black slots.

Figure 1: Attach ADF tray extension

Step two: Attach the front panel cover

Insert the two tabs of the front panel cover into the top slots on the product.
Figure 2: Insert front panel tabs
Tilt the cover down and press firmly. Make sure that the tabs lock into place and the cover is even with the product.
Figure 3: Press front panel down

Step three: Load paper

Remove the output tray.
Figure 4: Remove output tray
Slide out the paper-length and paper-width guides.
Figure 5: Slide out paper guides
Load clean, white, unused paper, and then adjust the paper guides snugly against the paper.
Figure 6: Adjust guides against paper
Pull out the tray extension.
Figure 7: Pull out tray extension

Step four: Connect the phone cord and power cord

Connect the phone cord from the product jack 1 to the wall jack.
Figure 8: Connect phone cord
1 - To wall jack
2 - To phone
Connect the power cord.
Figure 9: Connect power cord
1 - Power connection on the product
2 - Power adapter
3 - Electrical outlet
Press the Power button ( ) to turn the product on.

Step five: Insert and align the cartridges

Lift up the carriage door until it catches. Wait for the carriage that holds the cartridges to move to the center.
Figure 10: Lift carriage door
Remove any packing material from inside the product.
Lift the blue and gray cartridge latches.
Figure 11: Cartridge latches
Remove the cartridges from their packaging, and then remove the bright pink tape from each cartridge.
CAUTION:Do not touch the gold-colored contacts or retape the cartridges.
Figure 12: Remove tape from cartridge
With the label on top, slide each cartridge into the carriage.
Insert cartridgeInsert cartridge into slot
Close each latch, pressing down until the latch catches below the bottom tabs.
Close the carriage door, and then press Enter on the front panel to begin alignment.
After a page prints, alignment is complete. Discard or recycle the alignment page.

Links to software installation instructions

After you complete the previous setup steps, you can install the product software with the product CD or by downloading the software from the HP Web site. For instructions, click the link for your computer operating system.

CAUTION:Do NOT connect the USB cable yet. You will be prompted to connect it at the correct time during software installation.

Windows XP:	Installing the Product Software in Windows XP for a USB Cable Connection (c02283843) (in English)
Windows Vista:	Installing the Printer Driver Located in the Windows Vista Operating System (c00808543) (in English)
Macintosh OS X:	Installing the Product Software in Mac OS X for a USB Cable Connection (c02282571) (in English)