Jump to content
United States - English

Server Overview

Give us feedback

This document:
  • » Was helpful
  • » Was not helpful
  • » Does not apply

Support details

Product description
The HP Integrity rx4610 server is a 4-way capable server built around the 64-bit Itanium architecture. Containing two to four Itanium processors, implemented with HP's powerful combination of memory, I/O bandwidth and disk storage, the HP Integrity rx4610 server is an ideal way to next-generation, industry Itanium computing.
Product features
FeaturesSpecifications
ProcessorStandard 2 CPUs upgradeable to a maximum of 4 CPUs

  • Intel Itanium 733MHz, 266MHz effective FSB, integrated 2MB L3 cache
  • Intel Itanium 800MHz, 266MHz effective FSB, integrated 4MB L3 cache
  • Intel Itanium 1.3 GHz/3 MB cache
  • Intel Itanium 1.5 GHz/6 MB cache


CPUs can be installed one at a time CPUs must be installed in the following sequence: 0, 1, 2, 3 1.3 GHz and 1.5 GHz CPUs cannot be mixed in the same system
Memory
  • Minimum of 1GB RAM
  • 96 GB PC2100 ECC Registered DDR266A SDRAM (48×2GB DIMMs)


The HP Integrity rx5670 supports DDR (double data rate) SyncDRAM (synchronous dynamic random access memory) DIMMs with ECC and chip spare protection. The HP Integrity rx5670 supports up to two 24 DIMM memory carrier boards, for a maximum of 48 DIMMs. Each memory carrier board connects to the memory controller via a 6.4 GB/s memory bus. Peak memory bandwidth across both buses and both carrier boards is 12.8 GB/s.

Memory Loading Rules and Performance Guidelines
  • Memory must be installed in groups of four DIMMs, also known as quads
  • Each quad must consist of equal density DIMMs
  • Memory can be ordered in quads of 1 GB (4×256MB), 2 GB (4×512MB), 4 GB (4×1GB), or 8 GB (4×2GB)
  • Minimum memory is 1 GB (4×256MB)
  • Maximum memory is 96 GB, using twelve 4 GB memory quads in both memory carrier boards
  • Windows Server 2003 has a maximum memory configuration of 64 GB
  • HP UX 11i version 2 and Linux have a maximum memory configuration of 96 GB
  • Memory must be loaded in the order depicted on the memory carrier board
  • Arrange DIMMs so that the quads with the largest capacity are in the lowest numbered slots
  • Each memory carrier board has its own 6.4 GB/s bus. Configure both memory carrier boards to maximize bandwidth and performance
  • If both memory carrier boards are used, load memory equally across the carriers-alternate loading of DIMMs, in groups of four, between the two carriers.
Dimensions (h x w x d)31.12 x 44.45 x 71.12 cm (12.25 x 17.5 x 28.0 in)
Form factor4U
Mass storage shelves4 shelves total
  • One 3.5 inch LS-120 floppy
  • One DVD-ROM
  • Two 36GB HDDs are included on the two low-profile drive bays
Maximum internal storageStandard with 72GB (maximum capacity is 72GB)
Hot swappable drives36.4 GB 7200 rpm Ultra-3 SCSI
Expansion slots10 full-length PCI slots

  • Eight 64-bit / 66 MHz hot pluggable
  • Two 64-bit / 33 MHz non hot pluggable
ControllerEmbedded dual-channel Ultra-160 SCSI controller
NICintegrated Intel 82559 10/100TX NIC
Four power supplies (two power supplies per feed)
  • hot swappable 3+1 redundant power supply
  • withstands one power supply failure, but not one power feed failure
VideoEmbedded ATI Rage 128VR 64-bit SVGA video controller

16 MB onboard video memory (video controller supports pixel resolutions of up to 1600X 1200 and up to 16.7 million colors)
Removable media
  • One 120MB 3.5 inch LS-120 floppy
  • One DVD-ROM
Built-in I/O ports
  • Two serial ports (one convertible to server management port)
  • One parallel port
  • One SCSI port for external connection
  • One 10/100 LAN connector
  • Two USB Ports
  • Video port—SVGA
  • PS/2 keyboard and mouse
  • Two ICMB ports
Security
  • Startup password
  • Floppy, CD ROM, and hard disk boot disable
  • Enable or disable serial port, floppy drives, and write operations to floppy drive
Designed-in supportExtensive built-in self-tests
Software overview
Supported Operating Systems
  • HP-UX 11i version 1.5
  • Windows 64-bit
  • 64-bit Linux